Advertisement
13-10
FOLDING TOP
7 x 1 6 1 / 4
TACKS
TACKS
SCREWS
Fig. 13-16 — " F " Body Side Stay Pad Installation
retainer into front bow.
NOTE:
Retainer should be evenly centered
between side roof rail stay pads.
32. Install front bow to listing pocket retainer
attaching screws (Fig. 13-25).
33. On right side of top material, at front of
hold-down cable pocket, install cable through
pocket in top assembly.
NOTE:
Welding rod or similar material may
be bent at one end to form a hook. Then at rear
of hold-down pocket, slip hooked end of rod into
pocket. Push rod through pocket until hooked
end of rod is exposed at front of pocket. Install
rear end of cable attaching bracket over hooked
portion of rod; then pull cable through pocket.
When cable attaching bracket is exposed at
rear end of hold-down pocket, disengage hooked
portion of rod from cable attaching bracket.
Repeat above operation on opposite side of top
assembly.
pockets in top material, securely install front
and rear cable attaching brackets to side roof
front and rear rails (Fig. 13-3).
35. Check position of top trim at rear roof bow
and at side roof rear rails. With quarter flaps
properly folded over rear side roof rails (edge
of rails should match stitch lines of quarter
flap seams), marks on deck seam should be
in center of rear roof bow.
TACKING BACK CURTAIN
TO REAR TRIM STICK
2
«o
34. After cables have been inserted in hold-down
Fig. 13-17 —Back Curtain Installation
Advertisement
