Advertisement
14-12
DOOR, QUARTER AND SHELF TRIM
FOLDING TOP COMPARTMENT^
SIDE TRIM PANEL
TRIM
(FOLD-OVER
& CEMENT)
LOCK PILLAR
I FLANGE
VIEW B
TRIM RETAINER
TRIM PAD
1251
Fig. 14-21— Rear Quarter Trim Assembly - Convertible Styles
3. To install, reverse removal procedure.
pillar (Fig. 14-20).
REAR QUARTER TRIM ASSEMBLY
(HANG-ON TYPE)-"A, B & C" Bodies
(2-Door Styles)
1. Remove rear seat back and cushion assemblies
as described under "Rear Seats".
2. Remove window regulator handle and shoulder
strap buckle retainer if so equipped.
3. Remove arm rest as previously described.
4. Remove screw at rear upper corner of trim
pad on all convertible styles.
5. a. On "A" bodies, remove front door sill
plate and disengage rear body lock pillar
finishing strip. With a screwdriver, or
other suitable flat-bladed tool, disengage
trim assembly retaining clips from sealing
plugs along leading edge of rear body lock
Lift trim assembly upward to disengage top
of trim from top of rear quarter inner
panel.
NOTE:
On styles equipped with electric
window regulators, disconnect wire harness
connector from switch on trim assembly.
b. On "B & C" body styles use trim panel re-
moving tool (J-6335) or equivalent to care-
fully pry trim assembly retaining nails
from tacking strip; then lift trim assembly
upward to disengage from retainers at top
of rear quarter inner panel and remove
assembly from body.
6. To install rear quarter trim assembly, reverse
removal procedure.
NOTE:
Trim pad nailing strip replacement
tabs, or trim pad retaining clips and corre-
sponding sealing plugs are available as service
parts.
Advertisement
