Advertisement
FOLDING TOP
13-15
and rear trim stick attaching bolts. Forward
end of top compartment bag may be tied or
wired to center roof bow to provide ready
access to attaching bolts (Fig. 13-33).
17. At each rear quarter area remove attaching
bolts securing rear quarter trim stick as-
sembly
to rear quarter inner panel (Fig.
13-34).
18. Remove rear trim stick attaching bolts; then
lift trim assembly with attached quarter and
rear trim sticks on top of rear compartment
front panel.
19. To establish relationship of right and left inner
vertical edge of old top material to back
curtain assembly at rear trim stick location,
mark back curtain material at both locations
with a grease pencil (Fig. 13-35).
NOTE:
Reference marks must be made below
upper edge of rear trim sticks.
20. To establish relationship of old top material
to its position on rear trim sticks, cut selvage
end of top material off flush with lower edge
of trim sticks.
CAUTION:
When cutting top material, be
careful not to cut lower selvage edge of back
curtain assembly.
21. Using a pencil, mark both ends of rear and
rear quarter trim sticks on vinyl surface of
top material
as
shown in
Figure 13-36.
•A" BODY
• F " BODY
•A" BODY
" B " & " ( I
1 1
BODY
VIEW B
" F " .BODY
Fig. 13-31 —Convertible Top Material Hold Down Cable
Advertisement
