Advertisement
15-42
SEATS
SEAT
THIRD SEAT^CUSHION
SUPPORT BOLTS
1906
Fig. 15-52 —Folding Third Seat Cushion
FOLDING THIRD SEAT C U S H I O N -
Three-Seat Styles
Removal and Installation
1. Lift third seat cushion to a half raised position
or approximately vertical to floor pan (Fig.
15-52).
2. Remove four seat cushion screws from rear-
ward edge of cushion (Fig. 15-52).
3. Pull rear edge of cushion away from flange
of cushion panel then lift cushion upward to
disengage cushion border wire from four tabs
on panel. Remove cushion from body and place
on a clean protected surface.
4. To install, reverse removal procedure. Make
sure cushion border wire is engaged with all
four panel tabs prior to installing cushion at-
taching screws.
FOLDING THIRD SEAT CUSHION,
PANEL ASSEMBLY AND SUPPORT-
Three-Seat Styles
Removal and Installation
1. Lift third seat cushion to a half raised position
or approximately vertical to floor pan. (See
Fig. 15-52).
2. Remove two bolts at each side of seat securing
supports to body (Fig. 15-52); then, remove
seat cushion, panel assembly and supports
from body and place on a clean protected
surface.
To remove support, remove cushion from panel
assembly; then remove bolt securing support
to cushion (Fig. 15-53).
3. To install, reverse removal procedure. If
support was removed from seat cushion panel,
make sure bushing and spring washer are
properly installed. (See Fig. 15-53)
FOLDING THIRD SEAT BACK TRIM
ASSEMBLY-Three-Seat Styles
Removal and Installation
1. Raise third seat back assembly - leave cushion
assembly in down position.
2. Remove four screws securing lower edge of
seat back trim to seat back panel. (See Fig.
15-54).
3. Pull lower edge of seat back trim slightly
rearward; then, lift trim assembly upward to
disengage trim border wire from four tabs on
upper portion of panel. Remove trim assembly
from body and place on a clean protected
surface.
4. To install, reverse removal procedure. Make
sure seat back trim border wire is engaged
with all four panel tabs at upper portion of
panel prior to installing seat back trim at-
taching screws.
FOLDING THIRD SEAT BACK PANEL
ASSEMBLY-Three-Seat Styles
Removal and Installation
1. Remove third seat back trim assembly.
BOLT
SPRING WASHER
BUSHING
SUPPORT
1907
Fig. 15-53 — Third Seat Cushion Panel and Support
Advertisement
