Advertisement
6-72
DOORS
4. Remove window regulator attaching bolts (Fig.
6-89).
5. Remove regulator through large access hole.
On electric styles it will be necessary to press
lower end of ventilator division channel out-
board to permit removal.
6. To install, reverse removal procedure.
FRONT DOOR WINDOW REGULATOR-
Electric-"B-35-45 and 69" Styles
Removal and Installation
1. Remove front door window,and ventilator as
previously described.
2. On styles equipped with electric window regu-
lators, disconnect wire harness connector at
window regulator motor.
3. Remove window regulator attaching bolts (Fig.
6-96) and remove regulator through access
hole.
4. To install, reverse removal procedure.
FRONT DOOR WINDOW REGULATOR-
MANUAL-"B-11-35-45 and 69" Styles
Removal and Installation
1. Remove front door trim assembly and inner
panel water deflector.
2. Operate window to "full-up" position and se-
cure in place with pieces of cloth-backed body
tape applied over door frame.
3. Remove
inner panel cam as previously
described.
4. Remove ventilator division channel lower ad-
justing stud and nut and window regulator at-
taching bolts (Fig. 6-96).
5. Press ventilator division channel outboard to
permit disengagement of regulator spindle
from inner panel, then run regulator balance
arm roller and lift arm roller out of lower
sash channel cam at front. Remove regulator
through large access hole.
6. To install, reverse removal procedure.
BALANCE ARM
DOTTED LINE INDICATES
MOTOR HOUSING EXTENSION 1340
Fig. 6-97—Door Window Regulator and
Electric Motor Assembly
FRONT DOOR W I N D O W REGULATOR
ELECTRIC MOTOR
The electric motor assembly which powers the
electrically operated window regulators is a twelve
volt, reversible direction motor with an internal
circuit breaker and a self-locking gear drive. The
motor is secured to the regulator assembly with
bolts.
Removal and Installation
1. Remove front door window electric regulator
and clamp assembly in a vise (Fig. 6-97).
NOTE:
The position of regulator assembly in
vise will vary with type of regulator and posi-
tion of lift arm.
2. Drill a 1/4" hole through regulator back plate
and sector gear. The exact point of this hole
will be dependent on the position of the regu-
lator lift arm.
IMPORTANT:
DO NOT drill into the motor
housing, part of which is indicated by the dotted
line illustrated in Figure 6-97. In addition, lo-
cate hole sufficient distance from edge of
sector gear to insure proper retention of sec-
tor gear to back plate.
3. Install a 3/16" bolt through hole in regulator
back plate and sector gear and install a nut on
the bolt. DO NOT tighten nut.
CAUTION:
Be sure to perform steps 2 and 3
before attempting to remove motor from regu-
lator assembly. The regulator lift arm is un-
der tension from the regulator counterbalance
spring and can cause SERIOUS INJURY if
motor is removed from regulator without lock-
ing the sector gear in position with a nut and
bolt.
Advertisement
