Advertisement
14-20
DOOR, QUARTER AND SHELF TRIM
REAR QUARTER
FRONT TRIM
SPEAKER GRILLE
REAR QUARTER
TRIM ASSEMBLY
' - S P E A K E R
2 3 1 0
Fig. 14-35—Rear Quarter Trim Panel Right Side - " B " Station Wagons
REAR QUARTER FRONT TRIM PANEL
(RIGHT OR LEFT S I D E ) -
" A " Body Station Wagons
SPARE TIRE COVER PANEL-
" A " Body Station Wagon Styles
Removal and Installation
Removal and Installation
1. Disengage pinchweld finishing strip along rear
body lock pillar and remove rear door sill
plate.
2. Remove exposed screw at lower end of trim
panel (see Fig. 14-36 and 14-37).
3. With a flat-bladed tool, disengage trim retain-
ing clips from quarter inner panel (see view
"B" in Fig. 14-36).
4. Carefully swing rear edge of trim assembly
forward to break cement bond at body lock
pillar and remove rear quarter front trim
panel from body.
5. To install, reverse removal procedure. Prior
to installation of pinchweld finishing strip,
cement forward edge of trim assembly to out-
board surface of body lock pillar pinchweld
flange (see View "C" in Fig. 14-37).
The spare tire cover panel is retained at belt line
by a screwed-on garnish molding and at the load
floor level by a folding (catch-type) handle. To
remove cover, open catch handle and swing bottom
edge of assembly upward to disengage upper edge
from beneath garnish molding (see Fig. 14-36). To
install, reverse removal procedure.
WHEELHOUSE TRIM COVER PANEL
(RIGHT SIDE)—All " A " Body Station
Wagon Styles
Removal and Installation
1. Remove rear quarter front trim panel and
spare tire cover panel.
2. Remove second folding seat back catch and
bumper assembly from wheelhouse.
3. Remove all trim attaching screws at front,
rear and bottom of wheelhouse trim cover (See
Fig. 14-36).
Advertisement
