Advertisement
5-10
FRONT END
FRONT END PANEL MOLDING
MOLDING STUDS
RETAINER
LOCK
CYLINDER
VIEW A
U 3 8
3. To install, reverse removal procedure. Make
certain that molding is properly sealed to front
end panel.
FRONT COMPARTMENT LID LOCK
ASSEMBLY
Removal and Installation
1. Remove front end panel molding and lid lock
cylinder assembly.
2. Remove screws (Fig. 5-22) securing lock to lid
lock support and remove lock assembly.
3. To install, reverse removal procedure.
NOTE: If lock does not properly engage in
striker opening, the lock may be adjusted for-
ward by installing emergency spacer(s) be-
tween lock and support.
FRONT COMPARTMENT LID LOCK
STRIKER
Fig. 5-21—Front Compartment Lid Lock Removal
2. Remove lock cylinder retainer and remove
lock cylinder from molding.
LOCK ASSEMBLY
BOLTS
VIEW A
1437
Removal and Installation
1. Mark (pencil) location of front compartment
lid lock striker on striker support.
SCREWS
VIEW A
:
1436
Fig. 5-22—Front Compartment Lid Lock
Fig. 5-23—Front Compartment Lid Lock Striker
Advertisement
