Advertisement
13-26
FOLDING TOP
folding top side roof front rail to front bow
link.
14. Slide pocket on Silencer Assembly off front
roof bow and remove silencer from car.
Installation of Silencer Assembly
1. With deadener pad on top side of assembly,
slip pocket on assembly over front roof bow.
(View "B", Fig. 13-58)
2. Secure right side of front bow to folding top
side roof front rail to front bow link.
3. Apply nitrile type cement to front roof rail.
4. Stretching assembly taunt, cement assembly to
front roof rail.
NOTE:
Prior to cementing make certain as-
sembly is centered.
5. Tack outboard ends of assembly to front roof
rail (View "A" Fig. 13-58).
6. Cement assembly to side stay pads.
7. Cement side stay pad flaps to assembly.
8. Tack stay pad flaps to front roof rail.
9. Refer to steps 28 thru 32 of Installation proce-
dure of Folding Top Less Back Curtain.
10. When completed, folding top should be free
from wrinkles and draws. Install all previously
removed hardware and weatherstrips.
HYDRO-LECTRIC SYSTEM
DESCRIPTION
The high pressure hydro- lectric unit used in the
convertible bodies, consists of a 12 volt reversible
type motor, a rotor-type pump, two hydraulic lift
cylinders, and an upper and lower hydraulic hose
assembly. On the "A" Series the unit is installed
in the body directly behind rear seat back. (Fig.
13-59). On the "B, C & F" Series the unit is in-
stalled in the body beneath the rear seat back panel
(Fig. 13-60).
Figure 13-61 illustrates and identifies the individ-
ual parts of the motor and pump assembly.
NOTE:
When servicing the motor assembly or
pump end plate assembly, it is extremely im-
WIRING HARNESS
HYDRAULIC HOSE
RETAINING CLIPS
HYDRAULIC LINE CONNECTIONS / ^ _ ^ g \
CONNECTOR
^ J f e ^ ^ ^ ^ ^ ^ ^
^ ^ X \ ^ ^ ^
M O T O R AND P U M P
\ ^ ^ V ^ > ^
G R O M M E T
X
1
^
GROUND WIRE
ATTACHING SCREW
\
\
\
1722
portant that the small motor shaft "O" ring
seal is properly installed over the motor ar-
mature shaft and into the pump end plate as-
sembly prior to installing the pump rotors or
the motor shaft drive ball.
MOTOR AND PUMP ASSEMBLY
Removal
1. Operate folding top to full "up" position.
2. Disconnect positive battery cable.
3. a. On "A" Styles, place protective covering
over rear seat cushion and back.
Fig. 13-59 —Motor And Pump Assembly
Fig. 13-60 —Hydro-Lectric Motor And Pump Assembly
Advertisement
