Advertisement
15-54
SEATS
2. Remove hog rings securing seat back trim flap
to bottom of seat cushion (Fig. 15-77).
3. Remove seat cushion frame-to-seat back panel
attaching bolt (Fig. 15-76) from both sides of
seat; then, remove seat cushion assembly and
place on a clean surface.
4. As a bench operation remove hex-head screws
securing seat cushion trim to seat cushion
frame (Fig. 15-77) and three screws securing
rear edge of seat cushion trim to seat cushion
frame; then, remove cushion trim assembly
from cushion frame.
5. To install, reverse removal procedure. When
installing seat cushion f rame - to - seat back
frame attaching bolts install bolt bushing and
spring washer, as shown in insert of Figure
15-76.
FOLDING THIRD SEAT BACK TRIM ASSEMBLY
OR SEAT BACK PANEL ASSEMBLY-
" 6 5 " Styles
Removal and Installation
1. Remove folding third seat and floor panel as-
sembly, as previously described, and place on
a clean surface.
2. Remove hog rings securing seat back trim
flap to bottom of seat cushion (Fig. 15-77).
3. To remove seat back trim assembly remove
seat back trim-to-seat back panel attaching
screws (Fig. 15-77); then, lift trim assembly
upward to disengage wire loops on seat back
trim from slots in seat back panel and remove
trim assembly.
4. To remove seat back panel assembly, remove
seat cushion frame-to-seat back panel attach-
ing bolt (Fig. 15-76); then, remove seat back
panel with attached rear floor filler (at kick-
up) panel from seat cushion.
5. To install, reverse removal procedure. Refer
to inserts in Figure 15-76 for correct instal-
Fig. 15-77 —Folding Third Seat Assembly
Third Seat Back
Third Seat Cushion
Seat Back Trim to
Seat Back Panel
Attaching Screws
Cushion Trim to
Cushion Frame
Attaching Screws
Hog Rings Securing
Seat Back Trim
Flap
Location of Cushion
Trim to Cushion
Frame Attaching
Screws (Under
Trim Flap)
lation of linkage bolts, bushings and spring
washers.
LUGGAGE COMPARTMENT COVER PANEL
AND FILLER PANEL-"65" Styles
Removal and Installation
1. Raise luggage compartment cover panel and
support cover panel in up position.
2. Remove five hex-head screws securing cover
panel to cross bar; then remove luggage com-
partment cover panel and filler panel.
3. To install, reverse removal procedure.
SEAT BELTS A N D SHOULDER STRAPS
FRONT A N D REAR SEAT BELTS-
AM Styles
GENERAL INFORMATION
Front and rear seat belts are provided on all
styles. 1/2 inch - 13 UNC - 2N bolts are speci-
fied for all floor anchorages. Proper care of seat
belts will provide added security to driver and
passengers.
NOTE:
THE FOLLOWING PRECAUTIONS
SHOULD BE OBSERVED.
1. Keep sharp edges and damaging objects away
from belts.
Advertisement
