Advertisement
DOORS
6-95
UPPER H I N G E TO
CENTER PILLAR SCREWS
LOWER H I N G E TO
CENTER PILLAR SCREWS
Fig. 6-119-—Rear Door Hinge Attachment
3. Remove inside locking rod to lock connecting
rod link attaching bolt (Fig. 6-121).
4. Remove lock attaching screws (Fig. 6-122
hardtop style shown, closed styles similar).
5. Disengage connecting rods from clips on door
lock (for clip disengagement refer to "Door
Lock Spring Clips" in Front and Rear door
section) and remove lock from door.
6. To install, reverse removal procedure. Check
lock for proper operation prior to installing
water deflector.
REAR DOOR LOCK ASSEMBLY AND
VACUUM ACTUATOR-AII Except
"B 35-45 and 69" Styles
Removal and Installation
1. Remove door trim assembly and inner panel
water deflector.
2. Operate glass to full-up position.
3. Working through access hole, disengage lock
connecting rods from spring clips on door lock
(for clip disengagement refer to "Door Lock
Spring Clips'' in Front and Rear Door Section).
4. Remove door lock attaching screws (Fig. 6-122)
and remove lock from door.
5. To install, reverse removal procedure.
NOTE:
On styles equipped with vacuum lock
actuators (except 68069-169 styles), disconnect
vacuum hoses from actuator and remove lock
and actuator as an assembly. Vacuum actuator
is attached to lock with screws which can be
removed only in a bench operation (Fig. 6-123).
On 68069-169 Styles, remove vacuum actuator
and link assembly screws (Fig. 6-124 and 6-
125) and allow vacuum actuator to hang loose
during lock removal.
UPPER HINGE TO
DOOR SCREWS
LOWER HINGE TO
DOOR SCREWS
Fig. 6-120 — Rear Door Hinge Attachment
Advertisement
