Advertisement
6-52
DOORS
1. Window rear guide
bolts
2 . Lower Sash Channel
Cam Attaching Screws
Fig. 6-72 —Front Door Hardware - " F " Styles
3. Inner Panel Cam
Bolts
4. Regulator Bolts
5. Remote Control Bolts
6. Ventilator Division Channel
Lower Stud and Nut
7. Ventilator to Door
Inner Panel Screw
CAUTION:
Care should be exercised to make
certain glass does not strike body metal during
installation or removal procedure as edge chips
can cause solid tempered safety plate glass to
shatter. DO NOT attempt to grind glass.
Removal and Installation
1. Remove door trim assembly and detach inner
panel waer deflector.
2. On styles so equipped, remove inner panel
cam.
3. Remove glass run channel lower rear retainer,
front door ventilator assembly and inner belt
strip (draft strip).
4. Raise door window to a position of almost fully
closed. On styles equipped with a double arm
regulator, rotate balance arm close to lift arm.
5. Move door window forward to disengage regu-
lator arm roller(s) from window lower sash
channel cam and remove door glass outboard of
door upper frame on "A" Body Styles and in-
board of door upper frame on "X" Body Styles
(see Fig. 6-69 for "A" Bodies and Fig. 6-70
for "X" Bodies).
6. To install, reverse removal procedure.
Adjustments
A slight amount of fore or aft adjustment is avail-
able at the ventilator division channel lower adjust-
ing stud and nut as explained under "Front Door
Advertisement
