Advertisement
15-10
SEATS
Fig. 1 5 - 7 - F r o n t Seat Assembly - Six-Way - " B & C "
Styles
Track Cover Support
Adjuster-to-Seat Attaching
Screws
Rear Vertical Gearnut
Track Cover Support
E . Horizontal Actuator
F . Horizontal Cables -
Black
G . Motor and Transmission
Support Attaching Screws
H. Motor Attaching Screws
I . Transmission Attaching Screws
J . Rear Vertical Cables - Blue
K. Front Vertical Cables - Yellow
L . Front Vertical Gearnut
NOTE:
When installing horizontal actuator,
adjust actuator so that drive gear is fully en-
gaged with teeth on lower channel. When hori-
zontal actuator attaching screws are tightened,
there should be no free motion between upper
and lower channels. Readjust actuator "as
required
7
' until all free motion between chan-
nels has been removed. Check operation of
seat adjusters and make sure adjusters are
"in phase
;
\ See step 6 under "Front Seat
Assembly - Removal and Installation'\
JACKSCREW-"A" Body
Removal and Installation
1. Remove adjuster vertical gearnut as previ-
ously described.
2. Remove seat adjuster-to-seat bottom frame
front and rear attaching bolts on side affected
(Fig. 15-6).
Advertisement
