Advertisement
DOORS
6-37
WOODEN BLOCK
UPPER HINGE TO BODY]
ATTACHING BOLTS-THREE
ALUMINUM HINGE)!
PROTECTIVE TAPE
! LOWER HINGE TO|
BODY ATTACHING BOLTS|
f
'THREE)|
WOODEN BLOCK
Fig. 6-45 —Front Door Hinge Attachment - " A " Styles
Removal and Installation
1. Raise door window, remove door trim pad and
detach inner panel water deflector.
NOTE:
Some " E " Body Styles are equipped
with two remote controls, one front and one
rear. Attachment of both is the same; how-
ever, removal procedures differ in that the
forward remote (standard equipment) is located
in such close proximity to the window regulator
that regulator must first be loosened. This
can be accomplished by removing three of the
four regulator to inner panel attaching bolts
and pivoting regulator to a position that remote
can be removed (see Figure 6-37). On 26657
styles, remove window regulator two rear
attaching bolts and loosen front attaching bolts
("3", Fig. 6-52).
2. Remove bolts securing remote control to door
inner panel {"2", Fig. 6-52).
3. Inside of door, pivot remote control to disen-
gage lock connecting rod and remove remote
through access hole.
4. If remote control to lock connecting rod is to
be removed, refer to "Front and Rear Door"
section for method of disengaging spring clip
at lock end of rod.
Advertisement
