Advertisement
9-8
TAIL GATE
Fig. 9-13 —Tail Gate Window Hardware
1. Access Hole for Regulator Adjusting Screw
2. Access Holes for Window Regulator
Attaching Screws
3. Window Lower Sash Channel Cams
Attaching Screws
4. Lock Remote Control Attaching Screws
5. Lock Remote Control Handle Attaching Screw
6. Access Holes for Outside Handle or
Key Switch
7. Support Glass
3. Pull run channel(s) down into tail gate and
remove through inner panel access hole.
4. To install, reverse removal procedure.
TAIL GATE JAMB S W I T C H -
ELECTRIC STYLES
The electric jamb switch is used to prevent opera-
tion of the tail gate window with the tail gate in an
open position.
Removal and Installation
1. Remove screws securing jamb switch to tail
gate, disconnect attached wire and remove
switch. (See Fig. 9-15).
NOTE:
Figure 9-15
illustrates
the
jamb
switch on a "B" Body but is indicative of all
styles.
HANDLE (MANUAL)
/
SEALING
vv\/^
h
ESCUTCHEON (ELECTRIC)
. ^ ^
£ > _ SEALING
GASKET
>
GASKET
it-
A
HARNESS CONNECTOR
NUT
NUT
1623
Fig. 9 - 1 4 - T a i l Gate Outside Handle Assemblies
Advertisement
