Advertisement
13-6
FOLDING TOP
WIRE • ON BINDING
REAR ROOF
BOW
SECTION A-A
1521
Fig. 13-11—Spacer Stick Dimensions
MATERIAL PER STICK
Wood - 1/2 x 1 x 14-1/2
Steel - 1/32 x 1/2 x 2-1/2
Steel - 1/32 x 1-1/2 x 7
2 Screw #6 x 1/2"
Bolt 1/4 - 20 UNC - 2A x 1"
Wingnut 1/4 x 20 UNC - 2B
2 Washers 1/4" I.D.
Fig. 13-9-Rear Roof Bow Wire-On Binding
NOTE:
Dimension may vary ±1/4" after back
curtain has been completely installed. Readjust
spacer sticks and side roof rail* pads as re-
quired if rear bow does not come within this
position range.
CORD OK TAPE
5. Place new back curtain assembly on clean
covered work bench with interior surface of
back window facing down.
6. Carefully lay removed back curtain assembly
over new back curtain assembly.
Using a
grease pencil, mark vinyl surface of new back
curtain using marked edge of old curtain as
guide. (See steps 20 and 29 of removal proce-
dure.) In addition, mark trim stick bolt hole
locations on new back curtain assembly.
MARKS ON VINYL MATERIAL
INDICATING ENDS OF TRIM STICK
Fig. 13-10 —Spacer Stick Installation
Fig. 13-12—Marking Back Curtain
Advertisement
