Advertisement
11-8
HEADLINING
k. Finishing lace over front and rear doors.
1. Shoulder strap anchor plate and escutcheon
(if present).
3. Starting at front, carefully detach all cemented
edges of headlining material from retainers
and flanges.
4. Bend down tab at front Usting wire (View "H",
Fig. 11-7); remove listing wires from inner
rails. Gather or roll headlining with listing
wires on outside to keep headlining clean and
remove old headlining assembly.
IMPORTANT:
Note into which holes ends of
listing wires are installed in side roof rails.
Listing wires should be placed in same holes
when replacing headlining. If replacing head-
lining remove listing wires from pockets of
old headlining.
Installation
1. If previously removed, install listing wires
into pockets of headlining.
IMPORTANT:
Listing wires removed from
old headlining must be installed in correspond-
ing pockets of replacement headlining.
2. Apply approved trim cement to headlining at-
taching surfaces.
3. Apply approved trim cement to metal retainers
and flanges.
4. Lift headlining into body, install listing wires
into holes in side roof rail, center headlining
to roof, hook front listing wire over tab on roof
bow and bend down tab (View "H", Fig. 11-7).
NOTE:
Listing wires should rest tight against
roof panel. Working from front to rear, attach
headlining
to
retainers
and flanges while
stretching and removing wrinkles. Reinstall
all previously removed parts.
REAR HEADLINING ASSEMBLY
Removal
1. Place protective covering over seats and floor.
2. Prior to removing headlining, remove the fol-
lowing items:
a. Sunshade supports.
b. Front skylight c e n t e r
division garnish
molding.
c. Side skylight front upper garnish molding.
d. Rear roof headlining trim finish molding.
e. All finishing
lace around perimeter of
headlining.
3. Carefully detach headlining at cemented edges.
4. Starting at front remove listing wires from
roof inner rails (View "F», Fig. 11-7).
5. At rear listing wire bend down tab securing
wire to bow (View "I", Fig. 11-7).
6. Gather or roll headlining with listing wires on
outside to keep headlining clean and remove
headlining assembly from car.
Installation
1. If previously removed, install listing wires
into pockets of new headlining assembly.
IMPORTANT:
Listing wires removed from
old headlining must be installed in correspond-
ing pockets of new headlining.
2. Apply approved trim cement to attaching sur-
faces of headlining material.
3. Apply approved
trim
cement
to
retaining
flanges of roof panel.
4. Lift headlining into body, install center of
rear listing wire over hook at rear bow and
bend over tab (View "I", Fig. 11-7).
5. Working forward install remainder of listing
wires into clips and secure clips to roof
(View "F", Fig. 11-7).
6. Listing wires must rest tight against the roof.
If necessary adjust listing wires by moving
clips at attaching screws.
7. Attach entire perimeter of headlining to re-
taining flanges, removing wrinkles by stretch-
ing the material as required.
8. Replace previously removed parts.
Advertisement
