Advertisement
SEATS
15-41
LUGGAGE COMPARTMENT
CLOTH BODY TAPE
Fig. 15-50 —Rear Compartment Pan Side Filler Panels
2. On "45" Styles, raise folding 3rd seat back
assembly to up position; then raise 3rd seat
bottom cushion assembly to up or ' 'sitting"
position.
3. For right floor side panel, remove spare tire
cover panel.
4. On left side, remove screw which secures floor
side panel to panel support.
5. Along inboard and outboard side facing of right
and/or left panel, remove screws which secure
panel to panel supports (Fig. 15-50) and re-
move panel(s) from body.
6. To install, reverse removal procedure.
If
installing new filler panel, apply cloth body
tape over all screw attaching holes. (See Fig.
15-50).
LUGGAGE COMPARTMENT FRONT AND
REAR PANEL ASSEMBLIES-Two-Seat Styles
Removal and Installation
1. Using handle, fold rear luggage compartment
panel forward until it is resting entirely on
front luggage compartment panel.
2. Fold combined front and rear luggage com-
partment panels to "up " or half open position.
(See Fig. 15-50).
3. Remove bolt (Fig. 15-51) at both sides of front
panel securing front and rear panel assemblies
to supports; then remove assembly from body.
4. To install, reverse removal procedure. Make
sure bushing and spring washer are properly
installed (Fig. 15-51).
NOTE:
When replacing front luggage com-
partment panel with new part, transfer rear
luggage compartment panel with attached hinge
to new part.
LUGGAGE COMPARTMENT REAR PANEL
ASSEMBLY-Two-Seat Styles
Removal and Installation
1. Using handle, fold rear luggage compartment
panel forward until it is resting entirely on
front luggage compartment panel.
2. Remove screws securing hinge assembly to
rear luggage compartment panel and remove
panel assembly from body.
3. To install, reverse removal procedure.
LUGGAGE COMPARTMENT FRONT AND
REAR PANEL HINGE ASSEMBLY-
Two-Seat Styles
Removal and Installation
1. Using handle, fold rear luggage compartment
panel forward until it is resting entirely on
front luggage compartment panel.
2. Remove screws securing hinge assembly to
both front and rear panels and remove hinge
from body.
3. To install, reverse removal procedure.
BOLT
SPRING WASHER
BUSHING
LUGGAGE COMPARTMENT PANEL SUPPORT
1905
Fig. 15-51 —Luggage Compartment Panel Attachment
to Body
Advertisement
