Advertisement
TAIL GATE
9-5
Fig. 9-7 — Tail Gate Hardware - " A " Body Styles
1. Outside Handle or Key Switch
2. Sash Channel Cams
3. Locks
4. Lower Glass Run Channels
5. Inside Handle
TAIL GATE W I N D O W REGULATOR
MANUAL OR ELECTRIC
Removal and Installation
1. Remove tail gate window assembly.
2. On styles equipped with a power operated tail
gate window, disconnect electric harness at
regulator motor connector.
CAUTION:
DO NOT operate regulator motor
after window assembly has been disengaged
from regulator or after regulator has been
removed from tail gate. Operation of motor
with load removed may damage unite
3. Remove bolts securing regulator to support
and remove regulator, with motor attached,
from tail gate.
6. Torque Rod
7. Remote Control Connecting Rods
8. Remote Control
9. Regulator (Manual)
10. Regulator (Electric)
4. To install, reverse removal procedure.
TAIL GATE W I N D O W ELECTRIC
REGULATOR MOTOR ASSEMBLY
Removal
1. Open tail gate and remove tail gate inner cover
panel.
2. Detach inner panel water deflector and remove
inner panel right access hole cover.
3. Disconnect
w i r e
harness connector
from
motor.
IMPORTANT:
The following operation must
be performed if the window is removed or dis-
engaged from the regulator lift arms. The
Advertisement
