Advertisement
14-4
DOOR, QUARTER AND SHELF TRIM
DOOR PULL HANDLE
DOOR INNER
PANEL
SCREW
2299
SECTION " A - A "
Fig. 14-7—Door Pull Handle Retention - 49487 Style
with Custom Trim Shown
front handle and remote control cover plate at
rear for access to rear handle (Fig. 14-2).
DOOR TRIM ASSEMBLIES
All "B-C & E" Styles
The door trim assembly is secured to the door by
the trim support return flange which hangs over the
door inner panel across the top, and by a combina-
tion of retaining nails and screws down the sides
and across the bottom.
Removal and Installation
1. Remove all door inside handles as previously
described.
TOOL
w
!|
PUSH TOO
DIRECTION
j
L IN
OF
J-7797
ARROW
RETAINING SPRING
DISENGAGED^
\>£&
Mill
INSIDE HANDLE
1208
Fig. 14-8—Door Inside Handle Removal
On styles with door pull handles, remove
screws inserted through handle into door inner
panel. On some styles, removal of screws re-
moves handle. On other styles, handle will still
be retained to trim pad. Refer to "Door Pull
Handles" for specific types of retention.
NOTE:
On Buick 48400 Series, 2 screws be-
hind pull handle must be removed after pull
handle removal and prior to trim pad removal.
(Fig. 14-3)
On styles with switch plate located in arm rest
as shown in Figure 14-10, remove exposed
screws and disconnect switches from wire
harness connectors.
5. Remove all exposed screws present under
switch plate cover and/or directly under re-
mote control spindle. These screws secure the
trim pad to the door hanger plate. (Figure
14-9 show typical hanger plate attachment.)
4.
REMOTE CONTROL
COVER PLATE
2677
2. Remove inside locking rod knob.
Fig. 14-9—Arm Rest to Hanger Plate Attachments
Advertisement
