Advertisement
DOORS
6-49
FRONT DOOR VENTILATOR ASSEMBLY-
AM Styles Except " B - l l -35-45-57-69"
Styles
Removal and Installation
1. R e m o v e ventilator regulator a s previously
described.
2. Remove division channel lower adjusting stud
nut ("1", Fig. 6-67).
3. Remove ventilator lower frame adjusting stud
nut {"8", Fig. 6-67).
4. Remove ventilator frame to door outer panel
bolts ("9", Fig. 6-67).
5. Lift ventilator upward, then rotate it so that
division channel lower adjusting stud can clear
beltline.
6. To install, reverse removal procedure. Adjust
ventilator for proper operation and alignment
as described below.
Ventilator Adjustments
The ventilator assembly can be positioned up or
down, and fore or aft. In addition, the top of the
DOOR UPPER FRAME
TO VE
j
j
1
MA
NT SCREWS
^ _ - ^ ^ ^ l
Jr/m
f
I N V E N T FRAME TC
-a
f • I f
flT fmmMd*""*™ mm i
/jBIH^^HH
WINDOWHI^H
• • I I ^ ^ H H B O L T S J ^ ^ ^ I
MB9HP
^ • " V E I ^ T DIVISION O T A N " N E T M
^ B ADJU£ri|Nd STUD AHJBjjJiy
* ^ * *
S S S S S
* ^ ^
R U N
A D J U S T I N G
SSSSFWM
fo
f
Mm
«
tfffli
• •'-'* IK mil
0 M
ill
WHMT n
KwtKLJ
CHANNELEll
STUD AND NUT
2464
Fig. 6-65—Door Ventilator and Regulator
Attachment - " B " Closed Styles
BOLT
ADJUSTING
STUD & NUT
DIVISION CHANNEL
TO FRAME SCREW
VENT W/STRIP
BEND-OVER TABS
DIVISION CHANNEL
STRIP ASSEMBLY
Fig. 6-64 —Door Ventilator Front Frame
Attachments - " F " Styles
Fig. 6-66 —Front Door Ventilator Assembly -
" B " Closed Styles
Advertisement
