Advertisement
FOLDING TOP
13-23
Fig. 13-52 — Spacer Stick Installation
marks must be below trim stick so that they
will not show after curtain is installed in body.
4. Center and position back curtain assembly to
rear trim stick over attached compartment
bag.
NOTE: Notch in back curtain material at
lower edge indicates centerline of back curtain
assembly. (See Fig. 13-53). In addition, back
curtain lower edge should extend approximately
1/2" below lower edge of trim sticks.
5. Tack curtain to rear trim sticks (Fig. 13-53).
6. Tack remainder of back curtain material to
rear quarter trim stick (Fig. 13-54).
7. Tacks securing back curtain assembly to trim
sticks should be placed close to each side of
every bolt hole in trim sticks; then pierce or
punch back curtain assembly for each trim
stick bolt.
TACKING BACK CURTAIN
TO REAR TRIM STICK
2410
TACKING BACK CURTAIN
TO QUARTER TRIM STICK
Fig. 13-54 —Back Curtain Installation
8. On "B, C & A" Styles tack nylon webbing to
rear trim stick. Forward edge of webbing
should be even with edge of rear trim stick.
9. Inspect mastic type trim stick fillers at body
below pinchweld for sufficient seal at bolt holes
(Fig. 13-55).
10. Secure back curtain assembly with a sufficient
number of tacks to rear bow to prevent acci-
dental damage to back window.
MASTIC
FILLERS
STICK
2 1 8 3
Fig. 13-53 —Back Curtain Installation
Fig. 13-55—Checking Trim Stick Fillers
Advertisement
