Advertisement
SEATS
15-29
facing rearward (Fig. 15-35). Check for proper
operation of headrest.
STRATO SEAT BACK HEADREST SUPPORTS
Removal and Installation
1. Remove headrest assembly from seat back.
2. R e m o v e
s e a t back panel, as previously
described.
3. Remove headrest support finishing escutcheon
screw and remove escutcheon (Fig. 15-35).
4. R e m o v e
f o u r remaining support attaching
screws (Fig. 15-35), and remove support from
seat back. Where required, remove support
guide from support.
5. To install headrest support, reverse removal
procedure. Make certain lower end of plastic
guide is inserted into hole in bottom of support
and that cut out in guide for detent spring is
facing rearward (Fig. 15-35). Prior to tighten-
ing support attaching screws, install headrest
into supports and align support(s) with head-
rest arm(s); then, tighten support screws.
6. Check for proper operation of headrest.
Fig. 15-35 —Strato Seat Back Headrest Supports
1. Headrest Supports
2. Plastic Guide
Tube
3. Detent Sprint
4. Retaining Spring
5. Finishing Escutcheon
STRATO FRONT SEAT BACK LOCK, LOCK
CONTROL AND LOCK R O D -
(Two-Door Style Full Width Strato Seat and
Strato Bucket Seats Except Reclining
Strato Seat Backs)
Removal and Installation
STRATO BUCKET SEAT BACK ASSEMBLY-
AM Except "F and Z" Body Styles
and Strato Reclining Seat Back
Removal and Installation
1. Remove seat assembly from body, as previous-
ly described and place on a clean protected
surface.
2. With seat side panels removed, remove hog
rings securing seat cushion trim at rear of
seat and along bottom of seat and turn back
trim sufficiently to expose seat back hinge-to-
seat cushion frame attaching bolts (Fig. 15-36).
3. Remove seat back hinge-to-seat cushion frame
attaching bolts (Fig. 15-36) from both sides of
seat and remove seat back assembly from seat
cushion.
4. To install seat back assembly, reverse re-
moval procedure. Check for proper operation
of seat back lock.
1. Remove front seat assembly and front seat
back assembly, as previously described. Re-
move seat back panel as previously described.
2. Remove hog rings securing seat back trim to
seat back side bar; then, turn back trim suffi-
ciently to gain access to seat back lock and
lock striker attaching bolts (Fig. 15-37).
3. a. To remove seat back lock, disengage lock
rod clip at lock (Fig. 15-37) and detach rod
from lock. Remove bolts securing seat back
lock to seat back outer hinge (Fig. 15-37)
and remove lock from seat.
b. To remove seat back lock control, dis-
engage lock rod clip at control (Fig. 15-37)
and detach lock rod from control. Remove
lock control attaching bolts (Fig. 15-37) and
remove lock control from seat back.
c. To remove seat back lock rod. disengage
lock rod clip at lock and at control (Fig.
15-37), detach lock rod from control and
lock and remove from seat back.
Advertisement
