Advertisement
DOORS
6-47
CAUTION:
On "F" Body Styles, when remov-
ing ventilator, exercise care that "finger" of
ventilator (extension that contacts door window
front up-stop) does not damage belt seals. On
all styles, after ventilator has been removed,
door glass should be held or otherwise suitably
supported to prevent damage.
13. To install, reverse removal procedure.
Adjustments
It will generally be necessary to remove door trim
pad and detach inner panel water deflector (as re-
quired) prior to ventilator assembly adjustments.
In addition, removal of ventilator to door inner
panel and ventilator front frame to door hinge pillar
panel attaching screws is usually required.
1. A slight fore and aft adjustment of ventilator
division channel is available at lower adjusting
stud and nut by loosening attaching nut and
sliding stud in slot provided. The division
channel can also be positioned in or out by
loosening nut and turning stud in or out as
required and tightening nut.
2. The ventilator frame lower adjusting stud and
nut provides in or out adjustment by use of an
oversize attaching hole and fore or aft adjust-
ment by turning stud in or out as required.
NOTE: Adjustment No. 2 first requires loosen-
ing of ventilator front frame lower attaching
bolt (see Figure 6-64).
3. The effort required to open or close the ven-
tilator can be set by straightening retaining
washer tab and tightening or loosening the
adjusting nut. Tightening increases effort and
loosening decreases effort. When desired ad-
justment has been obtained, bend down washer
tab to lock nut in position (see Figure 6-62).
NOTE:
This adjustment should be performed
as a bench operation.
FRONT DOOR VENTILATOR ASSEMBLY
WEATHERSTRIP-"A" & "F" Body Styles
Removal and Installation
1. Remove front door ventilator assembly.
2. Remove ventilator division channel upper rub-
ber bumper attaching screw.
3. Remove two attaching screws securing ventila-
tor casting to frame and separate ventilator
TAB
ADJUSTING NUT
VENTILATOR FRONT FRAME
ATTACHING SCREWS
1335
Fig. 6-62—Front Door Ventilator Assembly -
" A " Style Shown - " F , X & Z " Similar
casting from frame so that the ventilator
weatherstrip can be removed (Fig. 6-62).
4. To install, reverse removal procedure. Prior
to installation, apply a ribbon of medium bodied
sealer
between ventilator weatherstrip and
casting.
FRONT DOOR VENTILATOR ASSEMBLY-
"B 11-35-45 and 69" Styles
Removal and Installation
1. Remove door trim assembly and inner panel
water deflector.
2. Remove
ventilator
regulator as previously
described.
3. Lower door window.
Remove bolt securing
ventilator lower frame to door outer panel
(Fig. 6-65).
4. Remove division channel lower adjusting stud
nut (Fig. 6-65).
5. Remove ventilator to door upper frame attach-
ing screws (Fig. 6-65). Disengage upper front
Advertisement
