Advertisement
SEATS
15-39
HANGER PLATE
SCREWS
ARM REST
CURTAIN
1953
Fig. 15-45 —Rear Seat Back Arm Rest and Hanger Plate
REAR SEAT BACK CENTER
ARM REST AND CURTAIN
Removal and Installation
1. Lower rear seat back arm rest. On all styles
except 68069 carefully pull upper portion of
arm rest curtain out of slot in hanger plate and
fold curtain forward. On 68069 Style fold arm
rest flipper forward.
2. Remove four screws securing arm rest to
hanger plate linkage then, remove arm rest
from seat back.
3. To install, reverse removal procedure.
REAR SEAT BACK CENTER ARM REST
HANGER PLATE AND LINKAGE
Removal and Installation
1. Remove rear seat back center arm rest; then,
remove two screws securing arm rest hanger
plate to body seat back support brace. Remove
rear seat back.
2. On back side of rear seat back, remove four
screws securing arm rest hanger plate to seat
back supports; then, carefully remove arm rest
and hanger plate assembly from seat back
(Fig. 15-45).
3. To install, reverse removal procedure. Prior
to tightening hanger plate screws move arm
rest assembly upward until top is snug against
top of opening in seat back.
STATION WAGON REAR SEATS
STATION WAGON FOLDING REAR
SEATS AND FLOOR PANELS-"B" Body
(Chevrolet 15-16000 Series and
Pontiac 25-26000 Series)
DESCRIPTION
The following views are typical of the station wagon
folding seats and rear compartment floor panels.
These illustrations identify the component panels of
the rear compartment area and their relationship.
All station wagon full width second seats incor-
porate a seat back lock located on the upper right
side of the seat back. On split second seat option,
a seat back lock is located at the upper outer side
of each seat back.
Figure 15-46 is typical of 15000 and 16000 two-
seat station wagons.
Figure 15-47 is typical of 15000 and 16000 three-
seat station wagons with split second seat option.
Figure 15-48 is typical of 25000 and 26000 two-
seat station wagons.
Figure 15-49 is typical of 25000 three-seat station
wagons with split second seat option.
REAR FLOOR TO TAIL GATE FILLER
PANEL ASSEMBLY 25-26000 SERIES
Removal and Installation
1. Lower tail gate assembly.
2. Lift up rear edge of filler panel assembly
sufficiently to expose attaching screws along
forward edge of panel.
Advertisement
