Advertisement
14-14
DOOR, QUARTER AND SHELF TRIM
WINDOW
SWITCH^
SWITCH
TERMINAL
.
J
A A
x
T
SECTION
VIEW
/
A-A
B
/
J—ARM REST
— ASH TRAY
CIGAR LIGHTER
1265
Fig. 14-25—Rear Quarter Arm Rest Ash Tray and
Cigar Lighter
REAR QUARTER TRIM ASSEMBLY
(INSERT TYPE)-"A, X & Z " Bodies
(2-Door Styles)
Removal and Installation
1. Remove window regulator handle and shoulder
strap buckle retainer if so equipped.
2. Remove rear seat back and cushion assemblies
as described in "Rear Seats".
3. Remove arm rest as previously described.
4. Remove door sill plate and lock pillar finishing
cap and disengage pinchweld finishing strip
along rear body lock pillar.
5. Remove all screws present along bottom of
trim pad.
6. On "Z" body styles only, remove 2 screws
securing ash tray housing to quarter inner
panel.
7. On all styles, carefully detach front cemented
edge of trim material from body lock pillar
pinchweld flange. Carefully bend or bow trim
inboard to sufficiently disengage upper edge of
trim from under finishing molding retainer
(Fig. 14-19, View "C"). In addition, "X" Body
style trim must be disengaged along bottom
from lower finishing molding retainer.
8. Carefully pivot trim assembly forward; then,
break cement bond along pinchweld flange of
REAR SEAT BACK
TO QUARTER INNER
FILLER PANEL
QUARTER TRIM
QUARTER
ARM REST
2478
Fig. 14-26-Quarter Trim Assembly - " F - 3 7 " Styles Only
FOLDING TOP SIDE
COMPARTMENT PANEL
QUARTER TRIM PAD
QUARTER ARM REST
Fig. 14-27-Quarter Trim Assembly - " F - 6 7 " Styles Only
Advertisement
