Advertisement
13-22
FOLDING TOP
GREASE PENCIL
MARK CURTAIN BELOW UPPER EDGE OF
REAR TRIM STICK\
1519
Fig. 13-48 —Locating Edge Of Top Material
INSTALLATION
1. Preset spacer sticks to shortest length and
install between center and rear roof bow (Fig.
13-52). Adjust sticks so that dimension "X" in
Figure 13-52 (measured along spacer stick
from front upper rolled edge of rear roof bow
to center of center bow) is 16-1/16" on "B &
C" Styles, 15-3/4" on "A" Styles and 13-3/16"
on "F" Styles.
NOTE:
Dimension may vary ±1/4" after back
curtain has been completely installed.
Tie or tape rear bow to rear side roof rails.
2. Place new back curtain assembly on clean
covered work bench with interior surface of
back window facing down.
WIRE - ON BINDING
REAR ROOF
BOW
SECTION A-A
1521
Fig. 13-50—Rear Roof Bow Wire-On Binding
Carefully lay removed back curtain assembly
over new back curtain assembly.
Using a
grease pencil, mark vinyl surface of new back
curtain using marked edge of old curtain as
guide. (See steps 7 and 14 of removal proce-
dure). In addition, mark trim stick bolt hole
locations on new back curtain assembly.
IMPORTANT:
Where a grease pencil or simi-
lar material is used for marking back curtain,
MARKS ON
VINYL MATERIAL
INDICATING
END OF
TRIM STICK
MARKS ON VINYL MATERIAL
INDICATING ENDS OF TRIM STICK
Fig. 13-49-Marking Top Material
Fig. 13-51 —Marking Back Curtain
Advertisement
