Advertisement
REAR QUARTER
7-9
Fig. 7-10—Rear Quarter Hardware - O.ldsmobile " E " Body
1. Rear Guide
2. Regulator Lift Arm Cam
3. Up-Stop
4. Front Guide
5. Regulator (Manual)
6. Regulator (Electric)
REAR QUARTER W I N D O W OUTER STRIP
ASSEMBLY-AII Closed Styles
1. Remove rear quarter trim assembly and inner
panel water deflector.
2. On "A & B" styles, disengage window assem-
bly from regulator lift arm by removing slotted
retainer (see Fig. 7-17). On "X" styles re-
move support to regulator plate screws (Fig.
7-18).
3. Lower window assembly to bottom of rear
quarter and rest it against outer panel.
4. On styles with screw retained strip assem-
blies, remove screws securing outer strip to
rear quarter outer panel return flange and
remove strip from body (see Fig. 7-23). On
styles with clip retained strip assemblies,
refer to index of "Door" section for removal
procedure.
NOTE:
Use care not to damage strip assem-
bly or adjacent painted surfaces.
5. To install, reverse removal procedure.
REAR QUARTER W I N D O W REAR
VERTICAL INNER SEALING STRIP
ASSEMBLY-"C-47" Styles
The rear vertical inner sealing strip assembly
serves as a glass run channel above the belt for
the rear quarter window. As shown in Figure 7-24
Advertisement
