Advertisement
8-4
REAR COMPARTMENT LID
tool J-22291 as shown in Figure 8-6. If tool is not
available, fabricate equivalent as shown in Figure
8-8. On " F " Styles use 1/4" I.D. pipe as shown in
Figure 8-3.
ENGINE COMPARTMENT LID SUPPORT-
Corvair Styles
Removal and Installation
1. Prop engine compartment lid in a full open
position.
2. Remove the two attaching bolts securing sup-
port to lid, the two bolts securing support to
wheelhouse and the single bolt securing support
to rear quarter bracket (see Fig. 8-4) and
remove support from body.
3. To install, reverse removal procedure. To
insure good operation, lubricate telescoping
channels of support with Lubriplate or its
equivalent.
3/8'
MATERIAL
1 PC. C.R.S. 12" X 1" X 3 / 8 "
1 PC. C.R.S. 1" X 1" X 3/8"
1568
Fig. 8-7 — Rear Compartment Torque Rod Adjusting Tool
REAR COMPARTMENT LID
LOCK CYLINDER
Chevrolet "B & X " Styles, Buick " A , B
f
C, E" Styles Oldsmobile "A & C" Styles
Removal and Installation
1. Open rear compartment lid. Remove lock cyl-
inder retainer attaching screw(s) located on
lid inner panel below lock cylinder and ad-
jacent to lid hemming flange (Fig. 8-9).
2. Pull retainer downward to disengage from lock
cylinder and remove. Lock cylinder and shaft
can now be removed from compartment lid
outer panel.
3. To install, reverse removal procedure. Make
certain lock cylinder shaft engages with lock
and that gasket mates properly with compart-
ment lid outer panel to form a watertight seal.
Check lock for proper operation.
REAR COMPARTMENT LID EMBLEM AND
LOCK CYLINDER ASSEMBLY-
AM Cadillac Styles
Removal and Installation
1. Open rear compartment lid. Remove access
hole cover screws at lower rear of lid inner
panel and remove cover.
2. Working through access hole, remove stud nuts
securing compartment lid emblem and lock
cylinder assembly and lock cylinder guard.
3. Remove guard through access hole, then re-
move compartment lid emblem and lock cyl-
inder assembly from lid outer panel (Fig.
8-10).
4. To remove lock cylinder from emblem, remove
lock cylinder shaft and spring and rotate cyl-
inder counter-clockwise.
5. To install, reverse removal procedure. Make
certain that emblem gasket mates properly
with lid outer panel and that emblem stud holes
are sealed to protect against waterleaks.
REAR COMPARTMENT LID LOCK
CYLINDER-Chevrolet "A & F", Pontiac
"A & B" (Except 26657) and
Oldsmobile " B "
Removal and Installation
1. Open rear compartment lid and remove screw
securing lock cylinder retainer to rear com-
partment lid lock support (Fig. 8-11).
Advertisement
