Advertisement
15-22
SEATS
2. Carefully pull curtain back sufficiently to re-
move screws securing center arm rest to
support linkage and loosen outer screws se-
curing curtain retainer to arm rest (Fig.
15-23).
3. Remove screw finishing covers (Fig. 15-23).
Disengage arm rest from support linkage and
turn arm rest upside down on trim panel fin-
ishing cover with curtain attached. Remove
three screws securing curtain retainer to trim
panel finishing cover (Fig. 15-23); then remove
arm rest and curtain from seat.
4. To install, reverse removal procedure.
FRONT SEAT CENTER ARM REST ASSEMBLY-
Front Seat with Notch Down Seat Back and
Strato Front Seat
Removal and Installation
1. Place arm rest in up position.
2. Working between arm rest and seat back, re-
move fastener at both sides of arm rest se-
curing front end of screw finishing covers
(Fig. 15-23).
LINKAGE SUPPORT
SCREWS
Fig. 15-24 —Front Seat Center Arm Rest Support
(Notch Down Seat Back)
3. Working at rear of seat, push one seat back
to full forward position. Carefully pull up
front of screw finishing cover sufficiently to
expost arm rest support attaching screws;
then remove screws (Fig. 15-24). Repeat this
operation on opposite side of arm rest; then
carefully remove arm rest assembly, including
trim panel finsihing cover, from seat.
NOTE: If washers are present between arm
rest support and supports on seat (Fig. 15-24),
note location and number of washers used to
facilitate installation in same position. Wash-
ers) are used to align arm rest to front seat
back(s).
4. To install, reverse removal procedure. Prior
to bending down screw finishing covers check
alignment and operation of arm rest. Where
necessary to align arm rest with seat back(s)
install washer(s), as required, between arm
rest support and supports on seat (See Fig.
15-24).
FRONT SEAT CENTER ARM REST SUPPORT-
Front Seat with Notch Down Seat Back and
Strato Front Seat
Removal and Installation
1. Remove center arm rest assembly.
2. Remove screws securing arm rest to support
(Fig. 15-23); then, remove support from arm
rest, finishing cover and curtain.
3. To install, reverse removal procedure. Prior
to bending down support screw finishing covers
check alignment and operation of arm rest.
Where necessary to align arm rest with seat
back(s), install washer(s), as required, be-
tween arm rest support and supports on seat
(See Fig. 15-24).
FOOT REST ASSEMBLY-Cadiliac 68169 Style
The folding foot rest assemblies shown in Fig.
15-25 are secured to the seat back by hinges. To
remove foot rest assembly, remove hinge-to-seat
back attaching screws from both sides of foot rest
(Fig. 15-25) and remove foot rest assembly from
seat back. To remove trimmed foot rest board
remove hinge-to-board attaching screws (Fig.
15-25) and remove hinges from foot rest board.
To install, reverse removal procedure. When in-
stalling foot rest hinge-to-seat back attaching
screws, install machine thread screws to upper
attaching hole at each hinge.
Advertisement
