Advertisement
DOORS
6-51
VENT FRAME TO
CASTING SCREW
DIVISION CHANNEL
TO CASTING SCREW
DIVISION CHANNEL
STRIP ASSEMBLY
VENT WEATHERSTRIP
BEND-OVER TABS
Fig. 6-68 —Front Door Ventilator Assembly -
"B-C" Hardtop Styles
The vent window and sash channel assembly can be
removed without removing the vent from the door,
however, the vent regulator must be removed (see
preceding removal procedure). With the regulator
out, open the vent window to align the bosses on the
T-shaft with the slots in the vent lower frame.
Then, press the vent window downward to disengage
the vent upper pivot from the vent casting. Remove
the vent window by lifting upward.
The division channel to casting screw (Fig. 6-68
DOOR GLASS
DOOR UPPER FRAME
R E p U LATO R L l 7 f A RMR^O L L E R \- -
1348
INNER PANEL CAM BOLTS
Fig. 6-70—Front Door Hardware - " X " Styles
also retains the top of the division channel strip
assembly. To remove the strip assembly, or to
gain aceoss to the vent weatherstrip bend-over
tabs (weatherstrip on division channel), remove the
screw and pull the strip assembly out of the divi-
sion channel.
FRONT DOOR WINDOW ASSEMBLY-
"A & X " Closed Styles
The front door window is a solid tempered safety
plate glass. The glass fits into a lower sash chan-
nel assembly which incorporates a welded-on lower
sash channel cam. With this type of design, the
door glass, lower sash channel and sash channel
cam are removed from the door as a unit.
Fig. 6-69—Front Door Window Removal - " A " Styles
Fig. 6-71 —Door Window Attachment - " E " Body Styles
Advertisement
