Advertisement
15-16
SEATS
LOWER CHANNEL AND PLASTIC SLIDES-
"B-C & E" Body
Removal and Installation
1. R e m o v e horizontal actuator as previously
described.
2. Slide seat adjuster lower channel from upper
channel until lower channel is completely dis-
engaged from upper channel. Remove plastic
slides from lower channel.
3. If lower channel is being replaced with a new
part, transfer plastic slides to new part (Fig.
15-14).
4. Apply "Lubriplate" (630AAW) or equivalent
to track portion of upper channel, plastic
slides and teeth on lower channel.
5. To install, reverse removal procedure. Be
sure adjusters are "in phase" before install-
ing seat assembly into body. (See step 6 under
" F r o n t
S e a t A s s e m b l y
- Removal and
Installation").
UPPER CHANNEL-"B-C & E" Body
Removal and Installation
1. Remove seat assembly from body and place
upside down on a clean protected surface.
2. Detach three power drive cables from adjuster
to be removed.
3. Remove screws securing seat adjuster to seat
bottom frame and remove adjuster from seat
assembly.
4. Remove horizontal actuator from upper channel
as previously described.
5. Slide lower channel until it is completely dis-
engaged from upper channel; then transfer
lower channel to new upper channel.
NOTE:
Be sure sliding surfaces of upper and
lower channels are properly lubricated with
"Lubriplate" (630AAW) or equivalent.
6. Transfer front and rear gearnuts to new upper
channel(Fig. 15-14).
7. Install horizontal actuator and actuator locating
spring to new upper channel.
8. Install adjuster to seat bottom frame; then
check all operations of adjusters. Be sure
adjusters are "in phase" prior to installing
seat assembly into body. (See step 6 under
" F r o n t
S e a t
A s s e m b l y - Removal and
Installation").
9. Install seat assembly into body. Operate seat
through several complete cycles to insure
proper operation.
HORIZONTAL AND VERTICAL DRIVE CABLES-
"B-C & E" Body
Removal and Installation
1. Remove front seat assembly from body with
attached adjusters, motor and transmission,
and place upside down on a clean protected
surface.
2. Detach both horizontal and vertical cables
from seat adjuster.
3. Remove screws securing horizontal and verti-
cal cable end plate on side of transmission
from which cables are being removed and re-
move cables from seat assembly; then dis-
engage cables from end plate.
4. To install horizontal and vertical cables, re-
verse removal procedure. Make sure colored
drive cables are installed to proper gearnuts
and horizontal actuator as shown in Figure
15-7.
TRANSMISSION-"B-C & E" Body
Removal and Installation
1. Remove front seat assembly from body with
attached adjusters, motor and transmission
and place upside down on a clean protected
surface.
2. Disconnect wire harness connector from trans-
mission.
3. Remove screws securing horizontal and verti-
cal cable end plate on both sides of transmis-
sion and detach cables from transmission.
4. R e m o v e
transmission to support attaching
bolts; then disengage transmission from motor
drive coupling and remove transmission from
seat assembly.
5. To install, reverse removal procedure. Make
sure seat harness is properly secured to seat.
Advertisement
