Advertisement
15-50
SEATS
securing folding seat front and rear linkage to
floor pan (Fig. 15-69 and 15-70).
2. Mark position of seat front and rear linkage
supports on floor pan to facilitate installation
of seat in same position.
3. Remove nut and washer assemblies securing
front and rear linkage to floor pan (Fig. 15-69
and 15-70); then, remove seat assembly from
body.
4. To install seat assembly, reverse removal
procedure. Align linkage floor pan supports
with previously made marks prior to tightening
nuts.
FOLDING SECOND SEAT CUSHION
ASSEMBLY-Right or Left S i d e -
" 6 5 " Styles
Removal and Installation
1. Remove folding second seat assembly from
car, as previously described and place on a
clean surface.
2. Remove hog rings and detach outboard rear
portion of trim sufficiently to remove three
screws securing seat outer link to cushion
frame (Fig. 15-71).
3. Remove three screws securing seat inner link
to cushion frame (Fig. 15-72); then remove
seat cushion and frame assembly from linkage.
If required, remove cushion front and rear
floor pan linkage.
4. To install, reverse removal procedure.
FOLDING SECOND SEAT BACK TRIM AND
SPRING ASSEMBLY-Right or Left S e a t -
" 6 5 " Styles
Removal and Installation
1. Fold second seat back forward.
AUTO - MAT OR CARPET
UPPER INBOARD SCREW
REAR FLOOR FILLER
PANEL RETAINER
REAR FLOOR
FILLER PANEL
DETACH OUTBOARD
REAR PORTION OF
CUSHION
T R I M
OUTER LINKAGE
TO SEAT BACK
PANEL SCREWS
SEAT OUTER LINK TO SEAT
CUSHION FRAME SCREWS
1209
Fig. 15-71 —Folding Second Seat Outer Linkage
Advertisement
