Advertisement
7-20
REAR QUARTER
NUT
SPACER
SASH
Fig. 7-29—Rear Quarter Window Assembly -
" E - 8 7 " Styles
The upper two adjusting studs of the rear quar-
ter window front guide are used for "in or out"
and "fore or aft" adjustment of quarter window
at front leading edge (see Section "D-D" in
Fig. 7-40).
4. The lower two adjusting studs of rear quarter
window front guide are adjustable "up or
dQwn" and "fore or aft" for proper operation
of quarter window (see Section "E-E" in Fig.
7-40).
5. A secondary up-travel stop is located at for-
ward end of sash channel cam (see Fig. 7-7).
REAR QUARTER WINDOW ASSEMBLY-
"B-C 47-57-67-87" Styles
The rear quarter window assembly consists of a
solid tempered
safety
plate
glass
window, a
pressed-on front vertical sash channel and a bolt-
on lower sash channel and cam assembly.
To service any of the component parts requires
moving the entire window assembly from the body.
Inaccessibility of the lower sash channel to glass
attaching bolts prevents separation of glass from
sash channel with window assembly installed.
Figures 7-41 and 7-42, which are exploded views
of the "47" and "87" style quarter windows, are
typical of all hardtop and convertible styles.
NOTE:
When reinstalling lower sash channel
and nylon rollers to quarter window, torque at-
taching nuts to 72 inch pounds (6 foot pounds).
Also, replace sash channel and nylon roller
rubber spacers.
Removal and Installation
1. Remove rear quarter trim assembly and inner
panel water deflector or inner panel access
hole cover. On "67" styles, lower folding top.
2. On "C-47" styles, remove roof rear drip
molding (see "Molding" section) and quarter
window rear vertical inner sealing strip as-
sembly as described in a preceding procedure.
Fig. 7-30—Rear Quarter Hardware - " E - 4 7 " Styles
Inner Panel Cam
Adjusting Studs
and Nuts
Glass Run Channel
Rear Adjusting
Stud and Nut
3. Regulator Attaching
Bolts
4. Regulator Lift Arm
to Cam Glass Roller
Attaching Nut
Advertisement
