Advertisement
DOORS
6-71
WINDOW REGULATOR
SCREWS^
REMOTE
CONTROL
SCREWS
1644
Fig. 6-95— Front Door Hardware - "Z"
Styles
5. Remove ventilator division channel lower ad-
justing stud and nut. On electric styles, dis-
connect wire harness from regulator motor.
6. Remove regulator attaching bolts and remove
regulator as follows:
a. On all "A" Styles, except "17 and 67"
Styles, work regulator rearward to dis-
engage lift arm from window lower sash
channel cam and remove regulator from
door.
b. On "A-17" and "67" Styles, slide regula-
tor forward to disengage lift and balance
arm rollers from lower sash channel
cam(s) and remove regulator through center
access hole.
c. On " E " Body Styles, remove regulator
through large access hole (See Fig. 6-93).
d. On " F " Body Styles, remove regulator
through large access hole (see Fig. 6-94).
e. On "X" Body Styles, slide regulator down-
ward and rearward and remove assembly
through forward loading hole.
f. On " Z " Body Styles, remove regulator
through large access hole (see Fig. 6-95).
7. To install, reverse removal procedure. Cycle
window several times to insure proper opera-
tion before installing water deflector and trim.
FRONT DOOR WINDOW REGULATOR-
Manual and Electric 26657 Style
Removal and Installation
1. Remove front door window assembly as previ-
ously described.
2. Remove inner panel cam ( " 1 " , Fig. 6-105).
3. On styles equipped with electric window regu-
lators, disconnect wire harness connector at
window regulator motor.
4. Remove window regulator attaching bolts ("2",
Fig. 6-105) and remove regulator through ac-
cess hole.
5. To install, reverse removal procedure.
FRONT DOOR WINDOW REGULATOR-
Manual and Electric-All "B & C"
Styles Except "B-l 1-35-45-57-69" Styles
Removal and Installation
1. Remove front door window assembly as pre-
viously described.
2. On two-door styles, remove ventilator division
channel lower adjusting stud and nut (Fig.
6-89).
3. On styles equipped with electric window reg-
ulators, disconnect wire harness connector
at window regulator motor.
DOOR UPPER FRAME
TO VENT SCREWS
VENT FRAME TO
OUTER PANEL BOLT
WINDOW
REGULATOR
BOLTS
VENT DIVISION CHANNEL
V ^
ADJUSTING STUD
A N D
^ ^ J ^ ^ M H J f i ' W
:
GLASS RUN CHANNELL
ADJUSTING STUD AND NUT
Fig. 6-96— Door Ventilator and Regulator
Attachment - " B " Closed Styles
Advertisement
