Advertisement
13-50
FOLDING TOP
REAR CONTROL
LINK ARM
MALE HINGE BOLTS
CONTROL
LINK BOLT
LIFT ASSEMBLY BOLT
Fig. 13-83 — " F " Body Convertible Top Linkage Attachments
c. Move hinge fore or aft as required to ob-
tain proper alignment between side roof
rail rear weatherstrip and rear quarter
window, then tighten bolts.
d. Lock front roof rail to windshield, (where
required; adjust front roof rail as previ-
ously described), and check fit at top ma-
terial at rear quarter trim stick; then
tighten trim stick attaching bolts.
e. On styles equipped with manually operated
folding tops adjust both folding top catch
clips as required. (See "Manually Operated
Folding Top Hardware").
2. If side roof rail is too high or too low at rear
quarter window area, proceed as follows:
a. Scribe location of male hinge attaching
bolt washers and control link on folding top
compartment brace.
b. Loosen
13-83).
male hinge assembly (See Fig.
c. Without changing fore and aft location of
male hinge, adjust male hinge up or down
as required to obtain proper alignment be-
tween side roof' rail and rear quarter
window.
d. Tighten attaching bolts, while maintaining
proper alignment of scribe marks.
e. Check fit of top material at rear quarter
trim stick area and, if necessary, adjust
trim stick. If adjustment is not necessary,
tighten trim stick attaching bolts.
f. On styles equipped with manually-ope rated
folding tops, adjust folding top catch clips
as required.
(See "Manually Operated
Folding Top Hardware").
Advertisement
