Advertisement
SEATS
15-21
SEAT BACK HEAD REST-
Standard Full Width Seat
(Drivers or Passengers Side)
The standard full width seat back headrest is s e -
cured by a support which is screwed or welded to
the seat back frame. The support incorporates a
detent spring which allows the headrest to be
raised or lowered to three different height positions.
The headrest can be removed from the seat back
for storage by pulling the headrest to the full up
position; then move headrest towards right side of
seat, pull headrest up and remove from seat back.
To remove and install the headrest support, the
seat back trim must be removed and the support-
to-seat back frame screws removed.
NOTE:
On styles where the support is welded
to the seat back frame, the welds must be cut
to remove the support.
FRONT SEAT CENTER ARM REST
ARM REST AND CURTAIN ASSEMBLY-
Front Seat with Standard Full Width Seat Back
Removal and Installation
1. Place center arm rest in down position.
CURTAIN
SCREWS
ARM REST
SUPPORT SCREWS
1952
2. At top of arm rest curtain, remove two screws
securing curtain to seat back frame (Fig.
15-22) and pull curtain forward to expose
screws securing arm rest to support linkage
(Fig. 15-22).
3. Remove arm rest-to-support linkage screws
(Fig. 15-22) and remove arm rest and curtain
from seat.
4. To install, reverse removal procedure.
ARM REST AND SUPPORT ASSEMBLY-
Front Seat with Standard Full Width Seat Back
Removal and Installation
1. Place center arm rest in down position.
2. At top of arm rest curtain, remove two screws
securing curtain to seat back frame (Fig.
15-22).
3. Remove two screws securing arm rest to sup-
ports on seat back (Fig. 15-22); then, carefully
lift arm rest and linkage upward to disengage
hooks of arm rest from slots in supports and
remove assembly from seat.
4. To install, reverse removal procedure. Prior
to installing curtain screws check alignment
and operation of arm rest.
FRONT SEAT CENTER ARM REST AND
CURTAIN ASSEMBLY-Front Seat with Notch
Down Seat Back and Strato Front Seat
Removal and Installation
1. Lower arm rest to approximately 2 inches
short of full down position.
CURTAIN RETAINER SCREWS
FINISHING COVER AND FASTENER
FOR LINKAGE SUPPORT SCREWS
Fig. 15-22 —Front Seat Center Arm Rest (Full Width
Seat Back)
Fig. 15-23 —Front Seat Center Arm Rest (Notch Down
Seat Back)
Advertisement
