Download Print this page

Fisher Chevrolet 13000 series Service Manual page 55

1967 body manual

Advertisement

FRONT END
5-11
2. Remove striker retainer plate attaching bolts
and remove retainer plate and striker (Fig.
5-23).
3. To install, position striker within scribe marks
and reverse removal procedure. Insure proper
engagement of striker to lock.
Adjustments
1. To adjust striker up, down, right or left,
loosen retainer plate attaching bolts (while
holding plate in position). Adjust striker as
required and tighten bolts.
NOTE:
Since the upper end of the lid lock
acts as a guide by entering the striker when
the lid is closed, align the front compartment
lid properly in the body opening prior to mak-
ing any striker adjustments.
FRONT COMPARTMENT LID GUTTER
WEATHERSTRIP
Removal
1. Separate "butt" ends of weatherstrip at front
of compartment opening.
2. With a flat-bladed tool, carefully disengage
weatherstrip from its cemented foundation in
gutter around entire perimeter of front com-
partment and remove weatherstrip.
Installation
1. Remove excess cement from gutter around
entire front compartment opening to insure
a smooth cementing surface.
2. Using a brush, apply approved sealer along
the base and around the entire perimeter of
gutter.
NOTE: Apply a sufficient amount of weather-
strip cement along lower inboard corner of
gutter so that after installation of weatherstrip,
cement will spread and fill complete area.
3. Center weatherstrip at area between lid hinges
using color or tape identification mark at
center of weatherstrip as guide.
4. Using a flat-bladed tool, such as a putty knife
with rounded corners, insert weatherstrip into
gutter across top, down sides and across top
front of compartment opening in that order.
Roll or press weatherstrip to insure a good
seal and proper retention of weatherstrip.
5. When a new weatherstrip is required, trim the
ends to form a "butt" joint at front of opening.
Using a brush, apply weatherstrip cement on
both ends of new weatherstrip and secure ends
together to form a matching joint.
6. Allow sufficient time for cement to set before
closing front compartment lid.

Advertisement

loading