Advertisement
SEATS
15-33
RECLINING SEAT BACK LOCK CONTROL
SUPPORT-Strato Full-Width or Bucket Seat
Removal and Installation
1. Remove front seat assembly, reclining seat
back and seat back panel, as previously
described.
2. At right side of seat back remove hog rings
and detach seat back trim sufficiently to gain
access to seat back lock control support (Fig.
15-39).
3. Remove control support attaching screws (Fig.
15-39) and remove support.
4. To install lock control support, reverse re-
moval procedure. Check for proper operation
of seat back lock.
RECLINING SEAT BACK LOCK CONTROL
ASSEMBLY-Strato Full-Width or Bucket Seat
Removal and Installation
1. Remove front seat assembly, reclining seat
back and seat back panel, as previously
described.
Fig. 15-39 —Strato Reclining Seat Back Lock
1 . Trim Retainer
2. Control
3. Control
4. Control
5. Control
Support
Assembly
Support Screws
Screws
6. Lock Rod
7.
8.
9.
10.
Seat Back Lock Bolts
Seat Back Lock Striker Bolts
Reclining Seat Back Hinges
Lock Rod Clip -
a. Engaged Position
b. Disengaged Position
2. Remove hog rings securing seat back trim
cover and padding to seat back frame and re-
move seat back trim cover and padding.
3. Disengage clip securing lock rod to control
assembly (Fig. 15-39) and detach rod from
control assembly.
4. Remove control support and control assembly
attaching screws (Fig. 15-39); then, remove
control assembly from seat back.
5. To install, reverse removal procedure. Prior
to installing seat assembly in body check for
proper operation of seat back lock.
MANUALLY OPERATED BUCKET
SEAT ADJUSTER
Removal and Installation
1. Remove bucket seat assembly, as previously
described, and place seat upside down on a
protected surface.
2. If replacing inboard adjuster, remove assist
spring (Fig. 15-40).
3. Operate adjuster so that both front and rear
adjuster-to-seat frame attaching bolts (Fig.
ADJUSTER-TO-SEAT
FRAME BOLTS
ASSIST SPRING
LEFT ADJUSTER
2203
Fig. 15-40 —Manual Bucket Seat Adjuster Removal
Advertisement
