Advertisement
DOORS
6-97
VACUUM ACTUATOR
DOOR
LOCK
VIEW IN DIRECTION
OF ARROW A
1 4 6 3
Fig. 6-123 —Rear Door Vacuum Lock Actuator
2. Dependent on body style and power options
involved, operate window to a position specified
in Figures 6-126, 6-127 and 6-128 to make
cam screws accessible and remove cam
screws.
3. On "Z" Styles, remove sash channel cam front
screw first, then, raise window and remove
rear screw. Support window during cam re-
moval.
4. On "A" Body Styles, remove front and rear
cam attaching screws with glass in the fully
lowered position.
INSIDE LOCKING ROD
TO LOCK CONNECTING
ROD LINK BOLT
DOOR LOCK
REMOTETO LOCK
CONNECTI
VACUUM /
HOSES
VACUUM ACTUATOR
AND LINK ASSEMBLY
1 6 6 4
Fig. 6-124 — Vacuum Lock Actuator
Removal - 68069-68169 Styles
Fig. 6-125 —Rear Door Vacuum Lock Actuator and
Link Assembly - 68069-68169 Styles
5. To install, reverse removal procedure.
REAR DOOR WINDOW STATIONARY
VENTILATOR DIVISION CHANNEL-
"X-35 and 69" Styles
The stationary ventilator division channel is held
into place by one division channel to door upper
frame attaching screw and one lower adjusting stud
and nut. This assembly acts as a rear door window
rear glass run channel and also holds the stationary
ventilator window in proper position.
Removal and Installation
1. Remove door trim assembly and detach inner
panel water deflector sufficiently to gain ac-
cess to the lower adjusting stud and nut (See
Fig. 6-129).
2. Remove door window lower stop.
3. Remove ventilator division channel lower ad-
justing stud and nut.
4. Carefully lower door window and remove divi-
sion channel to door upper frame attaching
screw (See Fig. 6-130).
5. Rotate upper section of division channel for-
ward and inboard and remove assembly from
door.
Advertisement
