Advertisement
SEATS
15-35
operated four-way seat adjuster, used on bucket
seats.
MOTOR AND TRANSMISSION
DRIVE BELT AND PULLEYS
Removal and Installation
1. At front of seat remove motor and trans-
mission drive belt cover attaching screws (Fig.
15-43) and remove cover.
2. Remove drive belt (Fig. 15-43) from both
motor and transmission drive pulleys. Pulleys
may be removed from either motor or trans-
mission by pulling pulleys off their respective
shaft.
3. To install drive belt, reverse removal proce-
dure. Check for proper operation of seats to
full limits of travel.
MOTOR ASSEMBLY
Removal and Installation
1. If motor can be operated, operate seat assem-
bly to full "up" position. Disconnect wire
harness connector from motor relay.
2. Remove motor-to-transmission drive belt cov-
er and drive belt, as previously described.
3. From under motor and transmission support
LEFT ADJUSTER
14
15
RIGHT ADJUSTER
16
17
19
VIEW A
19
20
LEFT ADJUSTER
2 2 0 7
Fig. 15-43 —Four-Way Bucket Seat Adjusters
1 . Motor and Transmission
Drive Belt Cover and
Attaching Screws
2. Transmission Drive Pulley
3. Transmission and Motor
Drive Belt
4. Motor Drive Pulley
5. Transmission Assembly
6. Electric Motor Assembly
7. Electric Motor Relay
8. Motor and Transmission
Support
9. Motor and Transmission
Support-to-Right
Adjuster Attaching Nut
10. Motor and Transmission
Support-to-Left
Adjuster Attaching Nuts
11. Adjuster Horizontal
Drive Cable
12. Adjuster Vertical Drive
Cable
13. Adjuster Torque Tube
14. Adjuster Vertical Gearnut
Shoulder Screw
15. Adjuster Vertical Gearnut
Assembly
16
17
18
19
20
Adjuster Vertical Jackscrew
Adjuster Vertical Jackscrew
Stop Nuts
Adjuster Horizontal
Actuator Assembly
Adjuster Horizontal
Actuator Attaching
Screws
20. Seat Side Panel Support
Advertisement
