Advertisement
FOLDING TOP
13-7
Fig. 13-13 — " A " Body Side Stay Pad Installation
IMPORTANT:
Where a grease pencil or simi-
lar material is used for marking back curtain,
marks must be below trim stick so that they
will not show after curtain is installed in body.
7. Center and position back curtain assembly to
rear trim stick over attached top compartment
bag.
NOTE:
Notch in back curtain material at
lower edge indicates centerline of back curtain
assembly (Fig. 13-17). In addition, back cur-
tain lower edge should extend approximately
1/2" below lower edge of trim sticks.
8. Tack curtain to rear trim sticks (Fig. 13-17).
9. Tack remainder of back curtain material to
rear quarter trim stick (Fig. 13-18).
10. Tacks securing back curtain assembly to trim
sticks should be placed close to each side of
every bolt hole in trim sticks; then pierce or
punch back curtain assembly for each trim
stick bolt.
11. On all "B, C & A" Styles, tack nylon webbing
to rear trim stick. Forward edge of webbing
should be even with edge of rear trim stick.
New webbing may be cut from a piece of non-
staining type webbing 2" x 24
M
for "A" Bodies
and 2" x 27" for "B & C" Bodies. Excess
webbing should be trimmed off at rear trim
stick,
1/2" above back curtain lower edge.
12. Inspect mastic type trim stick fillers to body
below pinchweld for sufficient seal at bolt holes
(Fig. 13-19).
13. Secure back curtain with tacks to rear roof
bow to prevent damage.
14. Install rear trim stick with attached back
curtain assembly into body.
NOTE:
Make sure that all trim stick bolts
are driven completely in to represent finished
condition.
15. Working from body center progressively out-
board to right and left sides, tack back curtain
to rear bow. Make sure all fullness has been
Advertisement
