Advertisement
7-26
REAR QUARTER
Fig. 7-43—Rear Quarter Hardware - " B - C " Coupe Styles
1. Rear Guide Adjusting
Studs and Nuts
2. Front Guide Lower
Adjusting Studs
and Nuts
3. Front Guide Upper
Adjusting Studs
and Nuts
4. Window Upper Stop
5. Window Lower Stop
( " B - C - 6 7 " and
" C - 5 7 " Styles
Only - See
Figure 7-44
for remaining
Coupe Styles)
WINDOW LOWER STOP
VIEW IN DIRECTION
OF ARROW " A "
QUARTER WINDOW
FRONT GUIDE
2 1 3 7
Fig. 7-44—Rear Quarter Window Lower Stop Adjustment
Styles so Equipped
REAR QUARTER WINDOW REAR GUIDE
ASSEMBLY-"A-X-Z" Hardtop and
Convertible Styles and "E-87" Styles
Removal and Installation
1. Remove rear quarter trim assembly and inner
panel water deflector (or access hole cover).
2. As shown in Figures 7-36, 7-38, 7-25, 7-26 and
all phantom views, rear guides are retained by
two (2) bolts or adjusting studs. By providing a
minimum of support for rear quarter window,
these bolts or stud nuts can be removed and
the guide disengaged from glass roller.
3. To install, reverse removal procedure. Adjust
guide for proper window operation as specified
under "Rear Quarter Window Adjustments".
REAR QUARTER WINDOW GUIDE
ASSEMBLY-AII "F" Styles
Removal and Installation
1. R e m o v e
rear
quarter
window
regulator
assembly.
2. Remove rear quarter window assembly.
3. Remove guide attaching nuts (3) and remove
guide through large access hole (see Fig. 7-33).
4. To install, reverse removal procedure.
REAR QUARTER WINDOW GLASS RUN
CHANNEL-"E-47" Styles
Removal and Installation
1. Remove rear quarter trim assembly and inner
panel water deflector.
2. Remove lock pillar grille (see Fig. 7-32).
3. Remove run channel rear attachment (on inner
panel - see Fig. 7-30) and forward attachment
(under lock pillar grille).
4. With rear quarter window fully forward, re-
move glass run channel in a rearward motion.
5. To install, reverse removal procedure.
Advertisement
