Advertisement
13-46
FOLDING TOP
TROUBLE SHOOTING CHART (CONT'D.)
CONDITION
APPARENT CAUSE
CORRECTION
E. Side roof rail rear weather-
strip too tight against rear
of rear quarter window.
F. Gap between side roof rail
rear weatherstrip and rear of
rear quarter window.
G. Side roof rail rear weather-
strip too tight against top of
rear quarter window.
H. Gap between side roof r a i l
rear weatherstrip and top of
rear quarter window.
I. Sag at front of center side
roof rail joint.
J. Front and center side roof
rails
bow upward at hinge
joint.
K. Folding top dust boot is diffi-
cult to install.
1. Male hinge a s s e m b l y mis-
aligned.
1. Male h i n g e assembly mis-
aligned.
1. Male hinge misaligned.
1. Male hinge misaligned.
1. Control
link adjusting plate
misaligned.
2. Center side roof rail hinge
adjusting s c r e w
improperly
adjusted.
1. Control
link adjusting plate
misaligned.
'2. Center side roof rail hinge
adjusting s c r e w improperly
adjusted.
1. Improper stack height due to
misaligned control link adjust-
ing plate.
2. Misaligned
folding top
boot female fastener.
dust
3. Rear seat back assembly is
too far forward.
4. Excessive build-up of padding
in side roof rail stay pads.
Adjust male hinge assembly rear-
ward (Fig. 13-81).
Adjust male hinge assembly for-
ward (Fig. 13-81) and/or shim
side roof rail rear weatherstrip
forward as required.
Adjust male hinge upward (Fig.
13-81).
Adjust m a l e h i n g e
downward
and/or s h i m s i d e r o o f
r a i l
w e a t h e r s t r i p downward as
required.
Adjust control link adjusting plate
downward (Fig. 13-81).
Adjust s c r e w
counterclockwise
(Fig. 13-82).
Adjust control link adjusting plate
upward (Fig. 13-81).
Adjust s c r e w clockwise (Fig.
13-82).
Adjust control link plate rear-
ward or forward as required (Fig.
13-81).
Where possible, align female with
male fastener.
Relocate rear seat back panel
rearward until dimension between
upper rear edge of rear seat back
to forward edge of pinchweld fin-
ishing molding is 21-11/16" ±
1/16". The dimension is meas-
ured at approximate centerline of
body.
Repair s i d e stay pads as
required.
Advertisement
