Advertisement
8-6
REAR COMPARTMENT LID
RETAINER ( GUARD)
LOCK CYLINDER &
EMBLEM ASSEMBLY
VIEW IN CIRCLE A
1267
Fig. 8 - 1 0 - R e a r Compartment Lid Lock Cylinder
and Emblem Assembly
REAR COMPARTMENT LID LOCK
Removal and Installation
1. Remove rear compartment lid lock cylinder
as previously described.
Fig. 8-11 —Rear Compartment Lid Lock Cylinder
Assembly - Chevrolet " F " Style Shown
1. Retainer Attaching Screw
2 . Lock
3. Retainer
4 . Gasket
5. Shaft
6. Cylinder
2. On styles so equipped, remove rear compart-
ment lid vacuum release unit.
3. Remove rear compartment lid lock attaching
bolts and remove lock from lid (Fig. 8-13 and
8-14).
4. To install, reverse removal procedure. Check
lock engagenlent with striker and make neces-
sary lateral adjustments before securing at-
taching bolts.
REAR COMPARTMENT LID LOCK STRIKER
Removal and Installation
1. Open rear compartment lid. Mark vertical
position of striker by scribing a line on striker
at top of striker support or at base of lid
inner panel.
2. Remove striker attaching screws and remove
striker (Fig. 8-13 and Fig. 8-14).
3. To install, reverse removal procedure. Close
lid to check lock to striker engagement and
make any necessary vertical adjustments be-
fore tightening striker screws.
REAR COMPARTMENT LID LOCK STRIKER
ENGAGEMENT-AII Styles Except Corvair
and Cadillac Styles with Mechanical
Closing Unit Option
IMPORTANT:
Since the rear compartment lock
frame acts as a guide when entering the striker,
make sure rear compartment lid is properly
positioned in body opening before performing
striker engagement check.
1. Insert a small quantity of modeling clay on
frame of lock at both sides of the lock bolt
(Figs. 8-13 and 8-14). Close lid with moderate
force.
Fig. 8-12—Rear Compartment Lid Lock Cylinder
Assembly - Oldsmobile " E " Style Shown
1. Retainer Attaching Nuts
2. Cylinder Attaching Nuts
3. Shaft
4. Cylinder
5. Gasket
6. Escutcheon
Advertisement
