Advertisement
7-10
REAR QUARTER
1. Rear Quarter Window
2. Sash Channel Cam
3. Sash Channel Cam Stop
Fig. 7-11—Rear Quarter Hardware - Cadillac " E " Body
4. Vertical Cam
5. Glass Run Channel
6. Glass Run Channel Strip
7. Regulator (Manual)
8. Regulator (Electric)
the strip assembly is retained by clips which snap-
over the leading edge of the quarter inner upper
panel.
To remove the strip assembly, it is necessary to
remove the rear quarter trim assembly and the
side roof rail rear finishing molding which covers
the sealing strip clips.
REAR QUARTER W I N D O W ASSEMBLY-
AM Hardtop and Convertible Styles
Except "B-C" Series
The rear quarter window is made of solid tempered
safety
plate glass. Consequently, it cannot be
drilled or ground, or develop scratches or edge
chips as it will shatter. The window assembly con-
sists of a pressed-on front vertical sash channel
and a bolt-on lower sash channel assembly.
NOTE:
When reinstalling glass to sash channel
bolts, or nylon roller nuts, torque to 72 inch
pounds (6 foot pounds). Also, replace glass to
sash channel spacers (rubber).
Refer to front of this section for hardware drawings
which can assist in performing any of the following
procedures. To perform any of these service oper-
ations, remove rear quarter trim assembly and
inner panel water deflector or access hole cover.
A. REMOVAL AND INSTALLATION-
"A-17 & 67" Styles
1. Lower folding top on "67" styles.
2. Remove rear guide upper and lower attaching
screws (Fig. 7-25 and 7-26). Disengage guide
from sash channel roller and remove guide.
Advertisement
