Advertisement
9-6
TAIL GATE
Fig. 9-8 —Tail Gate Hardware - " X " Body Styles
Outside Handle or Key Switch
Lower Sash Channel Cams
Locks
Lower Glass Run Channels
Inside Handle
regulator lift arms, which are under tension
from the counter-balance spring, can cause
serious injury if the motor is removed without
locking the sector gears in position.
4. Drill a 1/8" hole through regulator sector and
back plate. (See Fig. 9-12). DO NOT drill hole
closer than 1/2" to edge of sector gear of back
plate. Install a pan head sheet metal tapping
screw (#10-12 x 5/8) in drilled hole to lock
sector gears in position.
6. Torque Rod
7. Remote Control Connecting Rods
8. Remote Control
9. Regulator (Manual)
10. Regulator (Electric)
5. Loosen regulator right upper attaching screw.
Remove the three regulator motor attaching
screws and remove motor assembly from reg-
ulator and tail gate.
TORQUE ROD BEA
ATE SCREW
TORQUE ROD
RETAINER SCREWS
BODY
SIDE)*
RQUE "ROD RETAINER
SCREWS (GATE SIDE)
Fig. 9 - 9 - T a i l Gate Hardware " X " Body Styles
Fig. 9-10 —Tail Gate Inner Panel Cams Attachment
Advertisement
