Advertisement
UNDERBODY
3-9
Fig. 3-9—Front View of Cowl and Dash
dimension reference locations required for align-
ment of underbody assembly. Figure 3-9 speci-
fies cowl and dash reference locations required to
check the skirt assembly attaching hole locations.
Horizontal Dimensions
(Front End Skirt Assembly)
Fig.
Ref.
Dimension
A
30-5/32
B
35
C
46-3/16
D
25-29/32
E
20-7/8
F
90-19/32
Location
G
84-7/8
15/32" gage hole at front of
skirt side rails.
15/32" gage hole at front of
skirt side rail to forward gage
hole in dash front brace on same
side of body.
15/32" gage hole at front of
skirt side rail to forward gage
hole in dash front brace on op-
posite side of body.
Skirt panel inner surface adja-
cent to front suspension upper
control arm attaching points.
(See Fig. 3-11).
Front suspension lower control
arm adjusting cam guide (outer
edge of inner flange - See Fig.
3-10).
Front suspension lower control
arm adjusting cam guide (outer
edge of inner flange - See Fig.
3-10) to gage hole in lower
flange of rear spring front sup-
port on opposite side of body.
Front suspension lower control
arm adjusting cam guide (outer
edge of inner flange - See Fig.
FRONT
OF
CAR
REFERENCE POINT FOR
HORIZONTAL E , F & G
VERTICAL b
CAM GUIDE
OUTER
FLANGE
Fig. 3-10—Lower Control Arm Adjusting Cam Guide
Fig.
Ref.
Dimension
Location
3-10) to gage hole in lower
flange of rear spring front sup-
port on same side of body.
SKIRT ASSEMBLY
INNER SURFACE
r
REFERENCE POINT
LOCATION FOR DIMENSIONS
HORIZONTAL H, I, & J
VERTICAL c
UPPER CONTROL ARM
ATTACHING UNIT
1842
Fig. 3-11—Upper Control Arm Rear Attaching Stud
Advertisement
