Advertisement
14-18
DOOR, QUARTER AND SHELF TRIM
COMPARTMENT
FINISHING
SIDE MOLDING
QUARTER TRIM
PAD ASSEMBLY
VIEW A
2480
Fig. 14-30— Quarter Trim Assembly - Cadillac '^"Styles
5. Carefully bend or bow trim sufficiently to dis-
engage upper edge of trim from under head-
liner trim retainer and remove trim.
6. To install, reverse removal procedure.
REAR QUARTER INNER TRIM PANEL
(LEFT S I D E ) - " B " Body Station
Wagon Styles
Removal and Installation
1. Remove rear quarter stationary window front
and lower garnish moldings.
2. Remove all screws securing trim panel to rear
quarter inner panel (Fig. 14-34).
3. With a suitable flat-bladed tool, carefully dis-
engage trim retainers from rear quarter inner
panel along leading edge of rear body lock
pillar (on front edge of rear quarter front
trim assembly) (Fig. 14-34).
4. Lift assembly upward slightly to disengage
from rear quarter inner panel and remove
assembly from body. On styles equipped with
courtesy
lamp disconnect
feed wire from
switch and lamp (Fig. 14-34).
NOTE:
The rear quarter front trim assembly
can be removed at this point, as a bench op-
eration, by breaking cement bond between trim
PINCHWELD FINISHING STRIP
SCREWS
TRIM
SECTION B-B
1254
Fig. 14-31— Rear Quarter Trim Assembly - " A - 8 0 " Styles
and metal panel of rear quarter inner trim
panel assembly. The rear quarter front trim
i s a sub-assembly of the rear quarter inner
trim panel; left and right sides.
6. To install, reverse removal procedure.
SPARE TIRE COVER PANEL-
" B " Body Station Wagon Styles
The spare tire cover panel is secured to a retainer
TRIM ASSEMBLY
TRIM
EAR QUARTER
INNER PANEL
WINDLACE
SECTION A-A
TACKING STRIP
TRIM
NAIL
1300
V I E W B
Fig. 14-32—Rear Quarter Lower Trim Assembly -
"B & C " Body "39 and 6 9 " Styles
Advertisement
