Advertisement
REAR COMPARTMENT LID
8-9
t
«vj ACTUATOR STOP SWITCH
CABLE R E T A I N I N G CLIP
C O N D U I T TO BRACKET
R E T A I N I N G CLIP
tCABLE ADJUSTING BRACKJEJ
^
EW
CABLE CONDUIT
Fig. 8-19— Rear Compartment Lid Mechanical Pull-Down Unit
REAR COMPARTMENT LID MECHANICAL
PULL-DOWN UNIT CABLE-
All Cadillac Styles
Removal and Installation
1. On lower end of hydraulic cylinder pull clip
away from hooked end of pull-down unit cable.
Disengage cable from slot in cylinder. Dis-
engage cable conduit retaining clip from sup-
port on wheelhouse and remove cable and
conduit from support (Fig. 8-21).
2. Repeat this procedure at other end of cable,
disengaging clips securing cable to pull-down
unit and cable conduit to adjusting bracket (Fig.
8-19), and remove cable from body.
REAR COMPARTMENT LID MECHANICAL
PULL-DOWN UNIT HYDRAULIC
CYLINDER-AM Cadillac Styles
Removal and Installation
1. Disengage cable from lower end of hydraulic
cylinder as described under "Rear Compart-
ment Lid Mechanical Pull-Down Unit Cable -
Removal".
2. Lift cylinder to disengage upper end from
shoulder of shaft on link assembly and remove
cylinder.
3. To install, reverse removal procedure.
3. To install, reverse removal procedure.
Advertisement
