Advertisement
15-34
SEATS
? Ik
VIEW IN DIRECTION
OF ARROW " A "
/
y
DRIVE
Jr
C A B L E
-=*—
f
>l
\
MOTOR SUPPORT
AND SCREWS
- S E A T FRAME
ADJUSTER
y
BOLTS
"~7
2321
Fig. 15-41 —Power Horizontal Bucket Seat
Adjuster Removal
15-40) are accessible; then, remove attaching
bolts and remove adjuster from seat assembly.
4. To install, reverse removal procedure. If left
adjuster is being replaced, install new adjuster
control knob. Use rubber mallet to tap new
knob on control lever.
POWER OPERATED HORIZONTAL
BUCKET SEAT ADJUSTER
Removal and Installation
1. Operate seat to a midway horizontal position.
Remove bucket seat assembly, as previously
described, and place seat upside down on a
clean protected surface.
2. Disconnect power drive cable from adjuster
gearnut (Fig. 15-41).
3. Remove adjuster-to-seat bottom frame front
and rear attaching bolts (Fig. 15-41) and re-
move adjuster from seat assembly.
4. To install, reverse removal procedure. Where
spacers were installed between seat adjuster
and floor pan or seat adjuster and seat frame
make certain spacers are reinstalled. Check
for proper operation of seat to full limits of
travel.
POWER OPERATED FOUR-WAY
BUCKET SEAT ADJUSTER
Removal and Installation
1. Operate seat assembly to fully raised and mid-
way horizontal positions.
2. Remove front seat assembly from body with
attached adjusters, motor and transmission,
as previously described, and place upside down
on a clean protected surface.
3. If outboard adjuster is being removed, dis-
connect bolt, horizontal and vertical drive
cables from vertical gearnut and horizontal
actuator (Fig. 15-42).
4. Remove nuts securing motor and transmission
support to adjuster being removed (Fig. 15-43).
5. Remove adjuster-to-seat bottom frame front
and rear attaching bolts securing adjuster to
be removed (Fig. 15-42).
6. Carefully disengage adjuster from support, and
torque tube; then, remove adjuster from seat.
7. To install power operated four-way bucket seat
adjuster assembly, reverse removal proce-
dure. Check for proper operation of seat ad-
justers to limits of travel.
POWER OPERATED FOUR-WAY BUCKET
SEAT ADJUSTER MAJOR COMPONENTS
The following service procedures cover replace-
ment of the major component parts of the power
ADJUSTER
BOLTS
HORIZONTAL
DRIVE CABLE
VERTICAL
DRIVE CABLE
TORQUE TUBE
y
y
INBOARD
ADJUSTS
MOTOR ArHP ,
TRANSMISSION
SUPPORT
^""^
OUTBOARD
ADJUSTER
"V)
Fig. 15-42 —Four-Way Bucket Seat Assembly
Advertisement
